Before the installation of the induction faucet.Before we install the sensor faucet, we must turn off the water source of the water inlet, and ensure that the side of the induction faucet is facing down, so that the sensor faucet can be sensed after it is installed. The distance between the induction faucet and the bottom of the sink should not be less than 25cm, because if it is installed too close, it will affect the induction level and effect of the induction faucet. Induction faucet installatio.

First, we will take out the faucet of the induction faucet, and twist the thread that is in the water on the faucet body of the faucet, wrap it with the raw material tape or the anti-leak glue,and then screw the induction faucet into the pipe we need to install. Then come and fix it. Then we will disassemble the battery cover in the area where the top cover of the faucet protrudes, and then the battery case of the induction faucet can be pulled out, and then the new battery is placed according to the positive and negative electrodes of the battery. On the 3rd battery, the induction lamp of the induction faucet will be reflected at this time. After the induction lamp on the induction faucet stops flashing, the battery case is covered, so that the installation of the induction faucet can be completed. After the induction faucet is installed, we can open the switch of the inlet valve, and then experiment to see if the sensor faucet can work normally, so that we can know whether the installation of the sensor faucet is completed.